AQUANETT is a powerful water washable solvent free remover and cleaner that strips out new old and
encrusted oils from exterior wooden surfaces and cleans severely weathered wood.
Biodegradable AQUANETT is suitable for environmentally sensitive areas while its gel consistency means it will not run making it ideal for vertical surfaces.
Easy to apply and fast acting AQUANETT quickly and efficiently removes the mill glaze which is created in the manufacturing process from the surface of new wood thus improving the penetration and adhesion of a finish.
Surface preparation
Remove any loose and flaking finish.
Brush off any physical surface contamination e.g. moss general dirt etc.
Application Use as is Do Not dilute.
Work large areas in zones.
Always work in the direction of the grain. Do Not use a wire brush.
After rinsing immediately treat surface with NET-TROL while still wet.
Allow wood to dry thoroughly 2-3 days before applying the finish.
Test Procedure
Apply AQUANETT
Allow to work 5 minutes.
Scrub surface to see if finish or dirt is lifting.
If lifting commence with job if not wait a further 5 minutes and test again continue this process up to a
maximum of 20 minutes.
Stripping and Cleaning
Work in areas that can be completed in 5-20 minutes then move on to the next area until entire surface is
stripped or clean.
Apply AQUANETT to the area to be stripped or cleaned and allow to work.
After time established in the test scrub surface with a stiff nylon brush if required flush with water at the
same time OR use a pressure washer (max 60 bars/870 psi).
Thoroughly rinse the surface after stripping/cleaning including any adjacent areas with fresh clean water.
NB: The use of hot water makes the job easier.
